Positive Stops - Grizzly G5045 Instruction Manual

Positive Stops

The 45° and 90° positive stops ensure that the
blade adjustment stops accurately at both ends of
its swing. To adjust the positive stops:
1. Disconnect the saw from its power source.
2. Raise the blade to its maximum height.
3. Turn the tilting handwheel as far as it can
go clockwise. Place a square against the
blade. See Figure 17.
Figure 17. Checking blade angle.
-16-
If the square does not contact the blade evenly,
you will need to adjust the positive stop. To adjust
the positive stop:
1. Loosen the setscrew as shown in Figure
18.
Figure 18. Zero degree positive stop adjustment.
2. Using the handwheel, adjust the blade tilt
until the blade contacts the square evenly.
3. Advance the collar until it makes contact
with the bracket (C). Re-tighten the
setscrew.
4. Tilt the blades 15° and return it to the 0°
position. Re-check with your straight edge.
5. Re-adjust if necessary.
Once you are satisfied with the results, repeat the
process for the 45° positive stop. To adjust the
45° positive stop:
1. Tilt the blade to its maximum angle.
G5045 10'' Bench Top Table Saw