Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
If you wish to install the leveling hex bolts and hex
nuts included with the machine, begin assembly
with Step 1. If you have anchored your machine
to the floor, begin assembly with Step 3.
To assemble machine:
1.
Thread (4) M12-1.75 hex nuts all the way onto
(4) M12-1.75 x 50 hex bolts.
2.
Thread each hex bolt into corner bracket of
machine base (see Figure 14), then adjust
hex bolts to level machine.
Figure 14. Location of corner bracket threaded
hole.
3.
Tighten hex nuts against corner brackets to
secure setting.
4.
Remove (2) hex nuts, (3) hex bolts, and wash-
ers shown in Figure 15 to remove headstock
shipping bracket.
-18-
Note: Keep bracket in case you need to move
or ship machine. Bracket will keep headstock
aligned during transit.
Headstock
Shipping Bracket
Figure 15. Location of headstock shipping
bracket and fasteners (blade cover removed for
clarity).
5.
Slide work stop rod in hole in base of vise
until it protrudes from hole on other side, then
tighten (2) set screws shown in Figure 17 to
secure.
Figure 16. Work stop rod installed.
Note: Work stop rod can be installed on
either side of vise base, depending upon cut-
ting operation. It should be placed on same
side where workpiece is being cut. Refer to
Adjusting Work Stop on Page 36 for addi-
tional details.
Model G0592 (Mfd. Since 01/23)
x 2
Work Stop
Rod
Advertisement
Table of Contents
