Test The Interface With The Computer - Kyocera FS-600 Installation Manual

Test the interface with the computer

Notes on Application Software
In order to check that the printer and the computer are properly connected you must print by sending an
actual command from the computer.
1. Turn on the printer's power switch and turn on the computer's power as well.
2. Wait until the ON LINE/A4 indicator lights.
3. Enter and execute the following command at the DOS prompt on the computer screen.
ECHO !R! STAT; EXIT;>PRN
If this causes the printer to print a status page, then the printer and computer are properly connected. If
this does not print a status page, check that the printer cable is properly connected. The cable or one of
the connectors may also be broken.
The computer and printer have been successfully connected by the procedures up to this point. In order
to print from software run on the computer, it is necessary to install a printer driver on the computer to
which the printer is connected. After the printer driver is installed, be sure to make proper printer settings
from within the software.
Installing the Page Printer
21