Important Safety Information - Mira Extreme Thermostatic Installation And User Manual

IMPORTANT SAFETY INFORMATION

Warning!
1. Products manufactured by us are safe and without risk provided they are
installed, used and maintained in good working order in accordance with our
instructions and recommendations.
2. THIS APPLIANCE MUST BE EARTHED. MAKE SURE THE SUPPLEMENTARY
BONDING COMPLIES WITH THE "REQUIREMENTS FOR ELECTRICAL
INSTALLATIONS" BS7671. This electric shower is intended to be permanently
connected to the fixed electrical wiring of the mains system.
In accordance with the current edition of 'The Plugs and Sockets etc. (Safety)
Regulations in force at the time of installation, the Appliance is intended to
be permanently connected to the fixed electrical wiring of the mains system.
A means for electrical isolation of the appliance shall be provided in the fixed
wiring in accordance with local wiring regulations.
3. A separate, permanently connected supply must be taken from the consumer
unit to the appliance through a double-pole switch, which has at least 3 mm
contact separation. The switch can be a ceiling mounted pullcord type within
the shower room or a wall mounted switch fitted in the applicable zone area.
4.
This appliance must be provided with means for disconnection that is
incorporated into the fixed wiring in accordance with the relevant local wiring
regulations.
5. This product is suitable for installation within Zone 1 and is rated IP X4.
6. Switch off the appliance at electrical isolating switch when not in use. This is
for safety and is recommended with all electrical appliances.
7. DO NOT CONNECT THE APPLIANCE TO A MAINS-FED WATER SUPPLY.
Such a connection will damage the Appliance, and is not covered under the
manufacturer's guarantee.
8. The Appliance must not be fitted where it may be exposed to freezing conditions.
Make sure that any pipework that could become frozen is properly insulated.
9. To ensure the case and other components are not put under strain during
installation always provide mechanical support when making plumbing
connections. Upon completion of the installation ensure connections and
back case are not under any stress due to misaligned pipework or electrical
cables.
10. DO NOT switch on if there is a possibility that the water in the appliance is
frozen, isolate the electrical and water supply before removing the cover. Allow
the Appliance to thaw before using again.
5