Mira Extreme Thermostatic Installation And User Manual page 25

2.4 Remove the small label covering the
retaining screw on the temperature
hub. Unscrew the retaining screw
and remove the temperature hub.
Note! This will void the factory
setting.
Caution! When resistance is felt DO
NOT USE FORCE to turn the spindle
any further as this is the maximum
obtainable temperature from the
appliance with the available hot water
storage temperature. FORCE will
DAMAGE the internal components.
2.5 Turn the temperature spindle until the
required maximum water temperature
is obtained.
W a r m e r
anticlockwise
Cooler ⇒ Turn spindle clockwise.
2.6 Press the Stop button to stop the
water flow.
2.7 Refit the temperature hub with the
pip on the temperature hub aligned to
the slot on the thermostatic cartridge.
Secure with the retaining screw.
2.8 Refit the temperature knob.
Caution! If resistance is felt when
turning the temperature knob DO
NOT USE FORCE to turn the knob
any further as this will DAMAGE
internal components.
2.9 Check that the temperature knob can
be fully turned in both directions.
2.10 Check the maximum temperature
setting. If necessary repeat the
temperature adjustment until the
correct setting is achieved.
⇒ T u r n s p i n d l e
25
Temperature Hub
Temperature
Hub Retaining
Screw
Temperature
Spindle
Align the pip on the
temperature hub with the
slot in the thermostatic
cartridge.