Mira Extreme Thermostatic Installation And User Manual page 18

This procedure removes the top two blanking plugs from the inlet manifold for top
or wall entry pipe configurations. Using this procedure as a guide, adjust the steps
for bottom entry configurations as appropriate.
2.1 Unscrew the three cover retaining
screws sufficiently and carefully
remove the cover.
Note! The cover retaining screws are
captive and need not be removed.
2.2 Insert the push-fit release tool
between the flange of the blanking
plug and the collet for each of the top
ports for the inlet manifold, and lever
the plugs outward.
Whilst holding back on the collet, pull
out each appropriate blanking plug by
hand.
Cover Retaining
Screws
Blanking
Plug
Push-fit
Release
Tool
Inlet
Manifold
18
Cover Retaining
Screw