Table of Contents
Advertisement
3.8 Make sure that the end of the supply
pipework is cut squarely and free
from burrs which can damage the
inlet manifold seals.
Chamfer the end of the pipe to assist
insertion into the fitting and prevent
the 'O' seal tearing.
Warning! Do not insert fingers into
the push-fit connectors as this can
result in injury.
Caution! Thoroughly flush the
incoming hot and cold water
supply pipes to remove debris
be fore conn ect in g t h e M ira
Extreme shower.
3.9 Push the supply pipework inside the
inlet manifold until resistance is felt.
DO NOT FORCE!
Note! PTFE tape or liquid jointing is
not required to assist connection.
3.10 T h e c o l l e t a n d ' O ' s e a l w i l l
automatically make a hydraulic
seal.
Warning! This Mira Extreme must
be fixed to the wall at all three fixing
points. The fixing holes are elongated
to assist in vertical and horizontal
alignment.
3.11 Screw the Mira Extreme to the wall
using either the supplied wall screws
or alternative fixings depending on the
wall structure. Do not overtighten.
Make sure that the electrical supply
cable is correctly seated in the
channel in the back of the case.
21
Hide quick links:
Advertisement
Table of Contents
