Important Safety Information - Mira Mode Maxim Installation And User Manual

Important Safety Information

Products manufactured by Kohler Mira Ltd. are designed to be safe, provided that they are
installed, used and maintained in good working order, in accordance with our instructions
and recommendations. Follow all warnings, cautions and instructions contained in this guide,
and on, or inside the product. Failure to follow the instructions provided with this product
will invalidate the guarantee.
Warning! To reduce the risk of fire, electric shock or injury please read the important
information listed below.
1. Installation of this product must be carried out in accordance
with these instructions by qualified, competent personnel. Read
all instructions before commencing installation.
2. The electrical installation must comply with BS 7671 (commonly
referred to as the IEE Wiring Regulations) and all relevant
building regulations, or any particular regulation or practice
specified by the local electricity supply company.
3. The plumbing installation must comply with all national or local
water regulations and all relevant building regulations, or any
particular regulation or practice specified by the local water
supply company.
4. Isolate the electrical and water supplies before commencing
installation. Mains connections are exposed when the valve
module cover is removed.
5. The valve module must be earthed, ensure supplementary
bonding is provided in accordance with the wiring regulations.
6. The valve module must be permanently connected to a 3A fused
connection unit and be provided with means for disconnection
incorporated in the fixed wiring in accordance with the wiring
regulations.
7. We strongly recommend that a 30mA RCD is included in the
electrical supply to the valve module.
4
DO NOT
8. install the valve module, controller or the On/
Off Remote Button in areas with high humidity and temperature
(i.e. steam rooms and saunas).
DO NOT
9. install the valve module or fittings where they may be
exposed to freezing conditions. Ensure that any pipework that
could become frozen is properly insulated.
10. DO NOT perform any unspecified modifications, drill or cut holes
in the product other than instructed by this guide. When servicing
only use genuine Mira Showers replacement parts.
11. DO NOT operate the product if water is leaking from inside the
valve module. Isolate electrical and water supplies to the product
and refer to the fault diagnosis section.
12. DO NOT apply power to the product if it is thought to have been
exposed to freezing conditions. Isolate electrical and water
supplies to the product and contact Kohler Mira Ltd.
13. DO NOT allow children to play with the product.
14. DO NOT allow children to clean or perform any user maintenance
without supervision.
15. DO NOT remotely operate or alter any of the Mira Mode Maxim
shower settings if it is already occupied and / or being used by
another person.
16. If the valve module is dismantled during installation or servicing
then, upon completion, an inspection must be made to ensure
all electrical connections are secure and that there are no leaks.
17. Make sure that you fully understand how to operate this shower
and make sure that it is properly maintained in accordance with
the instructions given in this manual.
5