Table of Contents
Advertisement
Power button board
Description
Power button board
Power button board cable (included in Cable Kit)
Before removing the power button board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Place the computer in "Battery Safe mode"
3.
Disconnect all external devices connected to the computer.
4.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5.
Remove the following components:
a.
Service doors
b.
Hard drive
c.
Keyboard
d.
Top cover
Remove the power button board:
1.
Position the top cover upside-down.
2.
Disconnect the cable from the connector on the board (1).
3.
Remove the Phillips M2.0×3.0 screw (2) that secures the board to the top cover.
4.
Lift the left side of the board, and then pull the board to the left (3) to remove it from the top cover.
Reverse this procedure to install the power button board.
50
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Service doors on page
(Hard drive on page
38)
(Keyboard on page
41)
(Top cover on page
45)
(Battery Safe mode on page
32)
Spare part number
L00832-001
L00847-001
31).
Advertisement
Table of Contents
