User Lens Mode Ratio Setting [3]; Section 14: Key Operator Mode (Continued) - Oce 3275 User Manual

Key Operator Mode
User Setting Mode [3] (continued)

User Lens Mode Ratio Setting [3]

The preset and userset ratios available on the Basic Screen are used to reduce and
enlarge the original image to accommodate copy paper size.
Normally, users are allowed to change the three
User Lens Mode Ratio Setting Screen. The preset keys in the top and middle lines can
be programmed in 2-5 DIPSW mode for special purposes, but ordinarily, it is
recommended that they remain unchanged.
Setting options: Userset or Preset ratio
Default setting: USERSET1: 4.00
USERSET2: 2.00
USERSET3: 0.50
User Setting Mode Menu Screen
1 Press [ ] to display the Help Screen, then touch
HELP
Enter a 4-digit key operator password, then touch
Mode Screen.
NOTE: If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
2 Touch
[3] User setting mode
touch
[3] User lens mode ratio setting
Screen.
3 Touch the
USERSET
keypad.
If a ratio under 0.33 is entered, 0.33 will be displayed.
If a ratio over 4.00 is entered, 4.00 will be displayed.
4 Touch to complete the setting and return to the User Setting Mode Menu Screen.
OK
5 If no further changes are required, proceed to step 7.
6 If other user setting changes are required, touch the key.
7 Touch
PREVIOUS SCREEN
8 Touch
PREVIOUS SCREEN
14-14 Key Operator Mode
User Lens Mode Ratio Setting Screen
to display the User Setting Mode Menu Screen, then
to display the User Lens Mode Ratio Setting
you want to change, then enter a ratio from 0.33~4.00, using the
to restore the Key Operator Mode Screen.
to restore the Basic Screen to perform copying operations.
s in the bottom line on the
USERSET
Key Operator Mode
to display the Key Operator
OK
.