32
MPX Extender Installer/User Guide
5.
For each receiver that is intended to receive media from this transmitter, set the Bind Allowed
checkbox in the Configured Receivers table. The remaining receivers may be bound to a
different transmitter. Figure 3.4 on page 32 illustrates the Configured Receivers table.
6.
Click the Primary radio button to assign one unit as the Primary receiver for bi-directional
exchange of IR and serial data and reception of EDID information.
7.
Suggested: Set the Automatically Bind Detected Receivers pull-down menu to Disabled.
8.
Apply the changes.
Figure 3.4: Bindings Page
Firmware Version Checking
Select the Version Information web page on the transmitter. Make note of the firmware version of
the transmitter and each bound receiver. All units should be at revision 1.2.1.x or greater. Visit the
Avocent web site at www.avocent.com and review the available upgrades. Should you decide to
upgrade your units, see Upgrading MPX Firmware on page 93 for detailed instructions.
Receiver Configuration
Accessing your receiver's web interface
The on-board web interface of an MPX receiver may be accessed indirectly through the control
LAN port (L1) of the transmitter or directly via the control LAN port of the receiver itself.