b.
Type the subnet mask for L1.
c.
Type the gateway address for L1, or 0.0.0.0 if there is no gateway.
11. The LAN Speed / Duplex setting allows you manually select 10 or 100Mbps LAN speed and
full or half duplex operation. By default, these settings will be automatically negotiated with
your switch or hub. To ensure interoperability, compatible settings must be selected on the
Ethernet switch and MPX extenders.
12. Apply the changes.
NOTE: Once you change the IP address of a unit, the browser session will terminate. Your browser session must
be re-established using the new address of the unit.
Figure 3.1: Control LAN Settings
To configure transmitter source device settings:
The MPX1500 transmitter features a DVI-I dual-link media input port that supports DVI-D,
HDMI, DVI-A, RGBHV, and component video.
NOTE: Composite and S-video may also be supported depending upon the firmware revision of your transmitter.
To properly detect and process a video stream from a source device, the transmitter must be
properly configured. The Source Device Settings page is used to configure the transmitter for the
type of video to be received.
Figure 3.2: Transmitter Source Device Settings
Chapter 3: Installation
27