Figure 2.2: Emerge Mpx1000 Transmitter (Rear); Table 2.2: Rear Panel (Transmitter) - Avocent Emerge MPX Installer/User Manual

14 MPX Extender Installer/User Guide
Table 2.1: Front Panel (MPX1000 Transmitter) (Continued)
Item
Unit Reset
Infrared (IR) Receiver Port
Infrared (IR) Blaster Port
Omni-directional Antenna
Front Panel Display
Power (PWR) LED
USB Port
Power
USB

Figure 2.2: Emerge MPX1000 Transmitter (Rear)

Table 2.2: Rear Panel (Transmitter)

Item
L1 Ethernet Port
L2 Ethernet Port
Description
Recessed momentary button
Captures signals from an IR remote controller for broadcast
through the extension network
The dual IR(tx) emitter connects to this port via a 3.5mm jack
Used to establish the wireless link between the transmitter and
bound receivers; Avocent offers specialized antennas for
improved distance or higher performance in certain bands. See
the Avocent web site for more information.
Built into the unit; see MPX1000 Front Panel Display on page 60
LED built into the unit to indicate that power is connected and
switched ON
USB type A; reserved for future use
Serial
L2
L1
Description
RJ 45, 10/100 Mbps Ethernet for web-based management of the
MPX1000 transmitter
RJ 45, 10/100 Mbps Ethernet for transfer of A/V media from the
transmitter to all bound receivers
Media Module Slot