Table of Contents
Advertisement
TCP
SIP Time Interval
Timeout for Invite
Timeout for Ring Back
Timeout for Release
Registration Retry count
SIP User Agent name
Account Setting
There are two ports can be setup for SIP account.
Phone Number
Display Name
Authentication User Name User name for authentication. Maximum 36 characters
Authentication Password User password for authentication. Maximum 24 characters
TCP guarantees delivery of data and also guarantees that packets will be
delivered in the same order in which they were sent
SIP time interval in milliseconds. The default setting is 500 m-sec
INVITE message timeout value. Assigns a value 1 to 100, default setting
is 12 seconds. It denotes if an INVITE request was sent, and a response
is not received from the remote site within the allotted time. The present
request will be dropped and a new connection request will be initiated
Timeout value for dropping a call after receiving 180 responses. Ring
back is an intermittent audio tone that a caller in a telephone system
hears after dialing a number, when the distant end of the circuit is
receiving a ringing signal. It can be generated by the servicing switch of
either the called party or the calling party. It is not generated by the called
instrument. The default setting is 180 seconds
BYE message timeout value. Assigns a time interval 1 to 4, default setting
is 4 seconds
Assigns a value 1 to 65535, To set the retry count for keepalive
retransmission, use the retry keepalive command in SIP user agent
configuration mode. To restore the retry count to the default value for
keepalive retransmission, use the no form of this command
If specified, is the user-agent name to be used in a REGISTER request. If
not specified, the value in "SIP User Agent Name" will be used for
REGISTER request also. Default value is VOIP_Agent_001
Assigns Phone number for the first port, maximum 15 digits. Do not contain
any special characters or spaces. E.g. if you want to enter the number
+886 2 1234-5678, then it should be 886212345678
This text message will be sent between the callee and caller and will show
on LCD panel for general using
45
Advertisement
Table of Contents
