Table of Contents
Advertisement
Note
When WATA operates in AP-Client (or WISP & AP) Mode, the WAN
and LAN RJ-45 interface will be configured as a 2 port switch
for connecting with 2 PCs for access wireless network.
WLAN Mode
Remote AP SSID
Remote AP MAC
Remote AP Key
W-LAN Channel
W-LAN IP Assignment
Static IP
DHCP Client
WLAN SSID
Hide SSID
Authentication Method
Encryption Type
For wireless connected type 802.11 B/G mixed/ 802.11b only /
802.11G only
Define the same as your Wireless Router uses
Define the same as your Wireless Router uses
Enter the remote AP Authorization Key (WPA-PSK / WPA2-PSK /
WPAPSK ,WPA2PSK Mix Mode to Show)
Define the same as your Wireless Router uses
1.DHCP client
2.Static IP Address
Key in the W-LAN IP address, W-LAN Subnet mask and W-LAN
Gateway from WISP
When the DHCP Client is enabled, the WATA will get the IP Address
from Outdoor AP of WISP
The service set identifier assigned to the wireless network (WLAN).
Default SSID is SIP_ATA
Hide SSID prevents outside users from joining the network without
knowing the wireless Network's ID, default is check SSID
Define the same as your Wireless Router uses. (OPEN / SHARED
Mode)
Define the same as your Wireless Router uses. (OPEN / SHARED
Mode
28
Advertisement
Table of Contents
