Table of Contents
Advertisement
Administrator Name
Administrator Password
Confirm Password
Remote Administration Enable/Disable to access from remote site. Default setting is "Disable"
Http port for remote
Remote administration
only from IP
Example:
http://x.x.x.x:8080 where as x.x.x.x is the WAN IP address and 8080 is the port used for the
Web-Management interface.
Date/Time
Manual Time Setting：Set up the time manually.
Assign a name to represent the administrator account. Maximum 16
characters. Legal characters can be the upper letter "A" to "Z", lower letter
"a" to "z", digit number "0" to "9" and an underscore sign¡ "_".
The administrator name is case-sensitive. Note: the "blank" character is an
illegal character
Assign the administrator password. Maximum 16 characters and minimum
6 characters. Mix the characters with the digits. Legal characters can be
the upper letter "A" to "Z", lower letter "a" to "z", digit number "0" to "9" and
an underscore sign"_". The password is case-sensitive.
Note: the "blank" character is an illegal character.
Enter the administrator password again. Remote Administrator allows the
device to be configured through the WAN port from the Internet using a
web browser. A username and password is still required to access the
browser-based management interface
If you allowed the access from the remote site, assign the http port used to
access the ATA. Default port number is "8888"
Internet IP address of the computer that has access to the ATA. Assign the
legal IP address
62
Advertisement
Table of Contents
