Table of Contents
Advertisement
u
Signal Strength: Indicates the signal strength level.
u
Link Quality: Indicates the quality of active link.
u
TX/RX Frame: Shows the number of valid transmitted/received data frames.
3.2 More Setting...
You can access this screen by clicking on "More Setting..." button. It allows you to designate the
wireless network which WL-U351 intends to connect to, enable/disable the WEP data encryption,
save or load the setting values into/from a file, etc.
u
General Connection Settings: Displays information including Channel, SSID, Tx Rate and
Network Type. You can click "Change" button for modifying these values.
Ø
Channel: Shows the number of the radio channel used for the networking. Only
Access Points and Ad-Hoc nodes create the BSSID. This parameter is not active in
the Infrastructure operation mode.
Ø
SSID: Shows the SSID of the BSS that one willing to join.
Ø
Any: If "Any" check box is enabled, WL-U351 will survey and connect to one of the
available wireless stations without checking the consistency of channel and SSID
with the wireless station
Ø
Tx Rate: Shows the Data Transfer Rate. There are 1 Mbps, 2M bps, 5.5 Mbps, 11
Mbps, and auto mode. If Auto Mode is been selected, the device will select the most
suitable rate automatically.
11
Advertisement
Table of Contents
