Powerware 9155 User Manual page 75

Table 13. User Settings (continued)
Description
Automatic Battery Tests
Number of Battery Strings
Battery Capacity
Battery Low Alarm Level
Set Nominal Output Voltage
Bypass Voltage High Limit
Bypass Voltage Low Limit
Nominal Output Frequency
Synchronization
Synchronization Window
Unsynchronized Transfer to Bypass Allowed/Not Allowed
Usage of Bypass
Transfer to Bypass When Overload After a delay/Immediately
Automatic Start Delay
Automatic On Battery Shutdown
Delay
Control Commands from X-Slot1
Control Commands from
X-Slot2/Serv
X-Slot Signal Input Activation
Delay
Input signal delayed shutdown
delay
Powerware 9155 UPS (8–15 kVA) User's Guide
®
Available Settings
Enabled/Disabled
Enabled automatically runs the
battery test once a month.
0 through 22
(see "Configuring the UPS for
EBMs" on page 75)
1 through 65535 watts per cell
1.750 through 1.950 volts per cell
120V/240V
120V/208V
110V/220V
100V/200V
127V/220V
+1 through +20% (1% increments)
-1 through -20% (1% increments)
50 Hz or 60 Hz
Enabled/Disabled
±0.5 through ±3.0 Hz
(0.1 Hz increments)
Enabled/Disabled
-1 through 32767 seconds
(-1 means disabled)
-1 through 32767 seconds
(-1 means disabled)
Allowed/Disabled
Allowed/Disabled
0 through 65 seconds
1 through 65535 seconds
164201553 Rev D www.powerware.com
S
Default Setting
Enabled
2 strings for UPS-32 models
4 strings for UPS-64 models
34 W/cell
1.880 V/cell
120V/208V
120V +10%
120V -15%
60 Hz
Enabled
±2.0 Hz
Not Allowed
Enabled
After a delay
0s
-1s
Allowed
Allowed
5s
120s
Operation
69