Powerware 9155 User Manual page 37

Powerware 9155 UPS (8–15 kVA) User's Guide
®
5. Insert the two supplied nylon bushings inside the wiring access
holes on the UPS conduit landing plate (see Figure 15).
6. Remove the MBM/PDM wiring access cover and the conduit
landing plate and retain.
7. Tilt the top of the module forward and slide the module onto
the L-brackets. The top left flange on the module fits up under
the UPS electronics unit through an access slot.
UPS Electronics
Unit
Figure 15. Installing the MBM or PDM (MBM Shown)
164201553 Rev D www.powerware.com
S
UPS-Mounted Bypass Switch Installation
Nylon Bushings in UPS
Wiring Access Holes
MBM/PDM Wiring Access
Cover and the Conduit
Landing Plate (Removed)
31