Powerware 9155 User Manual page 32

Input Isolation Transformer Installation
26
Powerware
TB1 1
13. Replace the UPS wiring access cover and the input isolation
transformer wiring cover.
14. Continue to "Stabilizing the Cabinet" on page 49 to complete
the UPS installation.
15. On the input isolation transformer, punch one pilot hole in the
conduit landing for the input conduit using a Greenlee punch or
similar device (see Figure 9 on page 24).
16. Install the supplied edge grommet in the top of the input
isolation transformer wiring cover.
17. Hardwire the input (TB1-1 through TB1-3) terminations for the
input isolation transformer.
See Table 4 for specifications and Figure 9 for a detailed view of
the input isolation transformer terminal block.
18. Punch a hole in the bottom of the MBM/PDM using a Greenlee
punch or similar device for wiring access.
Insert the supplied nylon bushing inside the wiring access hole.
19. Continue to the following chapter, "UPS-Mounted Bypass Switch
Installation," to complete the installation.
9155 UPS (8–15 kVA) User's Guide
®
3 4 5 6
2
Input
Figure 10. UPS Terminal Block
164201553 Rev D www.powerware.com
S
7 8 9
Output