Powerware 9155 User Manual page 18

UPS Setup
12
Powerware
2. Remove the four M4 screws securing the stabilizing bracket to
the cabinet rear panel and remove the bracket (see Figure 3).
Retain the hardware for later use.
NOTE
Be sure to retain the stabilizing bracket and hardware for later
re-assembly onto the cabinet.
3. Remove the three M10 bolts securing the rear shipping pad to
the pallet and remove the shipping pad (see Figure 3).
NOTE
Hold the back of the cabinet so that the bolts can be removed
easily without the cabinet rolling backward.
4. Remove the two M10 bolts securing the front shipping bracket
and remove the bracket (see Figure 3).
Front Shipping
Bracket
M10 Bolts
Shipping Pad
Figure 3. Removing the Brackets and Shipping Pad
9155 UPS (8–15 kVA) User's Guide
®
Stabilizing
Bracket
164201553 Rev D www.powerware.com
S
M10 Bolts
M4 Screws