Yamaha Fazer Service Manual page 62

DRIVE CHAIN SLACK ADJUSTMENT
Â
ç
è
à Á
New
Å
3-21
ææææææææææææææææææææææææææææææææææ
Adjustment steps :
• Loosen both the Locknuts Â.
• Turn the Adjuster Á in or out until the speci-
fied Drive Chain slack is obtained.
Turning in ç Ÿ Drive Chain slack is
decreased.
Turning out è Ÿ Drive Chain slack is
increased.
NOTE :
• Turn each Chain Adjuster exactly the same
amount to maintain correct Axle alignment. To
check the alignment there are marks on Chain
Adjuster Ã. Ensure that left hand and right
hand chain alignment marks are equally
matched. Use them when adjusting the slack
for proper alignment.
• Before tightening the Axle Nut À and Driven
Sprocket Locknut to specifications, make sure
that there is no clearance at the Adjuster (or
the Swing Arm end) on both sides by pushing
the Wheel forward.
Nut (driven sprocket axle ) :
91 Nm (9.1m. kg., 66 ft-lb)
Nut (rear wheel axle):
91 Nm (9.1 m.kg, 66 ft.lb)
6. Install :
New
• Cotter pin Å
Into the Axle Nut and bend the end of the
Cotter Pin.
CAUTION:
WARNING
Do not loosen the Axle Nut after tightening
the torque. If the axle nut grooves is not
aligned with the Cotter Pin hole, align the
groove with the hole by tightening up the
Axle Nut.
WARNING
Always use a new cotter pin.
7. Adjust :
• Brake Pedal free play
Refer to "BRAKE FREE PLAY" section.
page no 3-18
INSP
ADJ