Yamaha Fazer Service Manual page 135

ENGINE ASSEMBLY AND ADJUSTMENTS
Engine Mount Bolt (Rear) :
38 Nm (3.8 m.Kg.27.5 ft. lb)
Bolt (Engine mount Stay) :
38 Nm (3.8 m..kg, 27. 5 ft.lt)
Engine mount bolt (upper)
38 Nm (3.8 m..kg, 27. 5 ft.lt)
Bolt (Engine Mount Stay front upper)
55 Nm (5.5 m.kg., 40 ft.lb)
À
¿
¿
À
Bolt (Engine Mount stay front lower)
55 Nm (5.5 m.kg., 40 ft.lb)
Engine Mount Bolt (Front lower)
38 Nm (3.8 m.kg., 27.5 ft.lb)
Engine Mount bolt (from upper))
38 Nm (3.8 m.kg., 27.5 ft.lb)
5. Install :
• Gasket
• Exhaust pipe ¿
Á
• Bolts Exhaust Pipe À - 2 nos
• Bolt (Muffler) Á
6. Install :
• Shift Pedal ¿
7. Tighten :
• Bolt Shift Pedal À
8. Install :
¿
• Stay Clutch Cable ¿
9. Install
• Clutch cable
• Adjust Clutch Cable free play at Lever end
Refer "CLUTCH ADJUSTMENT" in Chapter 3,
Page no 3-17
10. Adjust
Drive Chain Slackness
Refer
ADJUSTMENT" section in Chapter 3, Page
no 3-20
4-61
ENG
Bolts (Exhaust Pipe) :
10 Nm (1.0m. kg, 7.2 ft. lb)
Bolt (Muffler) :
15 Nm (1.5 m.kg, 11 ft lb)
Bolt (Shift Pedal):
10 Nm (1.0m. kg, 7.2 ft. lb)
Bolt (cable stay) :
7 Nm (0.7 m.kg, 5.1 ft. lb)
to "DRIVE CHAIN SLACK