Yamaha Fazer Service Manual page 131

ENGINE ASSEMBLY AND ADJUSTMENTS
Â
¿
Á
À
Ä
Ã
ê
é
ç
2. Install :
• Cylinder Head
• Bolt with Washer (Cylinder Head)
NOTE :
• Apply Engine Oil onto the Bolt thread
• Tighten the Bolts starting with the lowest num-
bered one.
3. Install :
¿
• Cam Sprocket À
À • Timing Chain ¿
ææææææææææææææææææææææææææææææææææ
Installing steps :
• Turn the Crank Shaft anticlockwise until the
slit ç (3rd Mark) matches the stationary
pointer è
• Align the "I" mark é on the Cam Sprocket with
the stationary pointer ê on the Cylinder Head.
• Fit the Timing Chain ¿ on Cam Sprocket À
and install the Cam Sprocket on the Camshaft.
è
NOTE :
When installing the Cam Sprocket , keep instal-
lation of the Camshaft. Damage or improper
Valve timing will result.
CAUTION:
WARNING
Do not turn the Crankshaft during installa-
tion of the Camshaft. Improper Valve Tim-
ing will result.
NOTE :
Remove the safety wire from the Timing Chain
before installation of Sprocket Cam.
ææææææææææææææææææææææææææææææææææ
4-57
ENG
Bolts (Cylinder Head ):
M8 (1-4) :
22 Nm (2.2 m.kg, 17 ft.lb)
M6(5-6) :
10 Nm (1.0 m.kg., 7.2 ft. lb)