Drive Chain Inspection - Yamaha Fazer Service Manual

DRIVE CHAIN AND SPROCKETS

DRIVE CHAIN INSPECTION

1. Inspect :
2. Inspect :
3. Measure :
NOTE :
• Tighten the Drive Chain with a fingers before
measuring
• 10 link length is the distance è between the
inside edge of Roller ¿ and É as shown.
• 10 link length measurement should be done
at two or three different places.
4. Clean :
6-17
CHAS
• Drive Chain stiffness
Stiffness Ÿ Clean and Lubricate or replace
• Drive Chain ¿
• Driven Sprocket À
More than 1/2 tooth wear ç Ÿ Replace
the Drive Chain and both the Sprockets as
a set.
• 10 link length è (Drive Chain)
Out of specification Ÿ Replace the Drive
Chain
10 link length limit :
127 mm
• Drive Chain
Put it in Kerosene and brush off as much
dirt as possible. Then remove the Drive
Chain from the ketosene and dry it.
Drive Chain Lubricant :
Engine Oil