Installation - Yamaha Fazer Service Manual

Ã
Â
À
Á

INSTALLATION

8. Install
¿
• Piston Valve Assy. with Diaphragm ¿
NOTE :
Hold the piston Valve Assy. with diaphragm
open condition and Aligns the diaphragn match
mark with carburetor mark,, Then put the pan
head with spring on Top of diaphragn press the
spring to same holding position of piston Valve
and tighten the screw pan head. After Tighting
the screw, Release the piston Valve Assy.
INSTALLATION
Reverse the "REMOVAL" procedure
1. Carburettor Inlet Manifold and tighten Air
¿
filter Hose.
Screw Front/Rear Clamp
2. Install :
Throttle cable assembly ¿ on carburettor.
3. Starter Cable assy À.
4. Connect :
• Over Flow Hose Á
• Air Vent Hose Â
• Fuel Hose Ã
5-7
CARB