CHECKING OF CONNECTIONS
CHECKING OF CONNECTIONS
Dealing with wire pressed stains, rust,
moisture etc. on the connector.
1. Disconnect
2. Dry each terminal with an air blower
3. Connect and disconnect the Connector two
4. Pull the lead to check that it will not come
5. If the terminal comes off, bend up the pin
6. Check for continuity with a tester.
NOTE:
• If there is no Continuity, Check/Clean the ter-
• Be sure to check the steps 1 to 6 listed above
• Use the tester on the connector as shown.
7-3
• Connector ¿
or three times.
off.
¿ and reinsert the terminal in to the con-
nector.
minals
when checking the wire harness.
ELEC