Electrical Safety; Electrical Supply - Xerox Color 550 User Manual

Safety

Electrical Safety

Warning
Do not push objects, including paper clips or staples, into slots or openings on the printer.
Making contact with a voltage point or shorting out a part could result in fire or electrical
shock.
Warning
Do not remove the covers or guards that are fastened with screws unless you are installing
optional equipment and are specifically instructed to do so. Power should be off when
performing these installations. Disconnect the power cord when removing covers and
guards for installing optional equipment. Except for user-installable options, there are
no parts that you can maintain or service behind these covers.
The following are hazards to your safety:
The power cord is damaged or frayed
Liquid is spilled into the printer
The printer is exposed to water
The printer emits smoke or the surface is unusually hot
The printer emits unusual noise or odors
The printer causes a circuit breaker, fuse, or other safety device to activate
If any of these conditions occur, do the following:
1. Turn off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.

Electrical Supply

This printer shall be operated from the type of electrical supply indicated on the printer's
data plate label. If you are not sure that your electrical supply meets the requirements,
please consult a licensed electrician for advice.
Warning
This printer must be connected to a protective earth circuit. This printer is supplied with
a plug that has a protective earth pin. This plug will only fit into an earthed electrical
outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact
a licensed electrician to replace the outlet.
1-2 Xerox Color 550/560/570 Printer
®
User Guide