Installation And Connections; Unpacking; Main Dial Attachment; Hexagonal Wrench - Icom IC-7700 Instruction Manual

2

INSTALLATION AND CONNECTIONS

■ Unpacking

■ Main dial attachment

q
Fig. 1
w
Shorter than
1 mm (
Fig. 2
e
Fig. 3
t
Front side
Fig. 4
Dial brake adjustment
1 / in)
32
r
Side view
After unpacking, immediately report any damage to the
delivering carrier or dealer. Keep the shipping cartons.
For a description and a diagram of accessory equip-
ment included with the IC-7700, see 'Supplied acces-
sories' on p. iii of this manual.
The main dial is shipped unattached to the transceiver
to prevent possible damage to the dial shaft or rotary
encoder during shipping. Please attach the dial as de-
scribed below.
R R CAUTION!: NEVER
knob(s), such as the main dial, when carrying or lift-
ing the transceiver. This will damage the dial shaft or
rotary encoder.
Once attaching the rubber cover to the main dial, it's
hard to remove. When you remove the rubber cover
from main dial, be careful to lack your nails and/or
damage to the transceiver.
q Slide the dial brake adjustment to the right position
(Fig. 1).
• The dial brakes move inward as shown.
w Insert the main dial set-screw into the screw hole of
the main dial, then tighten the screw until the screw
extends into the shaft hole out slightly using sup-
plied hexagonal wrench (2 mm) (Fig. 2).
• Be careful that the screw does not extend out more than
1
1 mm ( / in).
32
e Attach the main dial as illustrated (Fig. 3).
• Be careful to match the correct orientation of the flat face
of the shaft and the screw hole of the dial knob.
r Tighten the screw using supplied hexagonal wrench
as illustrated (Fig. 3).
t Install the rubber cover to the main dial (Fig. 4) little
by little.
• Be careful to match the correct position of the convex
part of the rubber cover and the concave part of the dial
knob.
• Never install the rubber cover on the main dial by force.
This may cause damage to the dial shaft or rotary en-
coder.
y Then adjust the main dial brake as desired.
2-2
hold any controller