Connections And Installation; Supplied Accessories; Basic Connections - Icom IC-GM800 Instruction Manual

■ Supplied accessories

Handset
Hex head bolts
(M6×50)
Weatherproof caps
Emergency frequency
sticker

■ Basic connections

CAUTION:
• After connecting an antenna, tuner control cables,
external speaker, or GPS receiver, cover the
connectors with rubber vulcanizing tape, as shown
below. Covering with the tape prevents water from
seeping into the connector.

CONNECTIONS AND INSTALLATION

DC power cable RCA cable
(Red and Black) (for the GPS connection)
Hex head bolts Spring washers (M6)
(M6×15)
Tuner connector kit Spare fuses (FGB 5 A)
Mounting bracket kit for the remote controller
Mounting bracket
Rubber vulcanizing tape
Mounting plates
for the main unit
Flat washers (M6)
Ferrite EMI fi lter
(for the DC power
cable)
Spring washers (M5)
Self-tapping screws (M5) Flat washers (M5)
• DO NOT pull the antenna and control cable
receptacles.
This may cause cable disconnection (in the tuner
unit), damage inside the connector, or a bad
connection.
NOTE: Turn OFF [DC ISOLATE] on the GM800
main unit, or charge the battery while at anchor,
otherwise the battery may become exhausted.
The GM800 has a high-stability ovenheater type
crystal oscillator, and the oscillator's heater is
directly connected to the DC power terminals. It
keeps its temperature to at a specifi ed level, even if
you turn OFF the power by holding down [ ] on the
remote controller.
GM800
NOTE: Must be used with the
9
Rubber feet
Hex nuts (M6)
Remote control cable
Knobs
ICOM AT-141.
8
9
78