Icom IC-7700 Instruction Manual page 93

D D Scope set mode (continued)
Scope during Tx (CENTER Type)
Turn display of the transmit signal ON and OFF.
Max Hold
Turn the peak level hold function ON and OFF.
CENTER Type Display
Select the center frequency of the spectrum scope
indication (center mode only).
Waveform Color (Current)
Set the waveform color for the currently received sig-
nals.
Waveform Color (Max Hold)
Set the waveform color for the received signals max-
imum level.
Sweep Speed (± 2.5k)
Select the sweep speed for the ±2.5 kHz span selec-
tion from SLOW, MID and FAST.
(±
Select the sweep speed for the ±5 kHz span selec-
tion from SLOW, MID and FAST.
(±
Select the sweep speed for the ±10 kHz span selec-
tion from SLOW, MID and FAST.
5k)
10k)
FUNCTIONS FOR RECEIVE
ON
NOTE: Transmit signal display is available for the
center mode only.
ON
Filter Center
• Filter Center
• Carrier Point Center
• Carrier Point Center (Abs. Freq.)
217
• The color is set in RGB format.
• Push [Ω ≈]
F-3
(Blue), and rotate the ratio from 0 to 255 range.
• The set color is indicated in the box beside the RGB
scale.
• The color is set in RGB format.
• Push [Ω ≈]
F-3
(Blue), and rotate the ratio from 0 to 255 range.
• The set color is indicated in the box beside the RGB
scale.
MID
NOTE: Signals may be displayed incorrectly with
"FAST" setting.
MID
NOTE: Signals may be displayed incorrectly with
"FAST" setting.
FAST
5-5
: Shows the selected filter's center
frequency at the center.
: Shows the selected operating
mode carrier point frequency at
the center.
: In addition to the carrier point
center setting above, the actual
frequency is displayed for the
bottom of the scope.
241
to select R (Red), G (Green) and B
58 110
to select R (Red), G (Green) and B
5
247
147