Kodak 3000 series User Manual page 26

Installing the Printer
NOTE:
CAUTION:
If you accidentally drop the wing screw inside of the printer body,
do not boot up your printer until the wing screw has been removed.
3. Use the two short wing screws and lock washers to fasten the printer on the stand.
See Figure 4.
4. Loosen the wing screw that is fixed to the printing table (4), and remove the metal
fixing plate (5). See Figure 5.
Note: Keep the metal fixing plate and wing screw. The printing head needs to be
blocked during shipment of your printer.
5. Remove the white tape (5).
6. Remove the cable block between the rail and cover. See Figure 6.
The bottom of the printer has four knobs that fit into the
holes in the stand.
The front of the stand is the side where the castor wheels
are located.
Figure 5
Figure 6
KODAK PROFESSIONAL Large
Format 3000 Series Inkjet Printers
Cable block
21