Kodak 3000 series User Manual page 72

Troubleshooting
8. Cannot cut the roll media cleanly.
Possible Cause
Is your cutting blade still
sharp enough?
Does the media have static
electricity?
9. Initial Ink replenishment does not work.
Possible Cause
Is the cover open or is the
hold lever in the UP position?
Are the four ink cassettes
installed correctly?
10. After Initial Ink replenishment, the Ink does not appear.
Possible Cause
Are the ink cassettes frozen?
Did you turn the power switch
OFF after replenishment?
After replenishment the
printer does not print
normally.
11. During the media loading sequence, media gets torn or gets jammed.
Possible Cause
Are you using approved
media?
Is the hold lever down?
In case of a cut sheet, is the
edge of the media aligned
with the leading edge of the
print plate?
In case of using roll media, is
the edge of the media parallel
with the edge of the printer
during the media detection
sequence?
Solution
Replace your cutting blade.
Remove the static electricity.
Solution
Close the cover or put the
lever in the DOWN position.
Make sure that all four ink
cassettes are installed
correctly.
Solution
After leaving them for at least
three hours at room
temperature, proceed with
cleaning several times.
Turn the switch back ON and
continue the replenishment.
Execute cleaning several
times, and check every time.
Solution
Use only approved media
Make sure to put the hold
lever in the DOWN position.
Align the edge of the cut
sheet with the leading edge of
the print plate.
The roll media and the
baseline should be installed
parallel.
KODAK PROFESSIONAL Large
Format 3000 Series Inkjet Printers
Reference
Maintaining the
Printer
Setting Up the Printer
Reference
Setting Up the Printer
Setting Up the Printer
Reference
Setting Up the Printer
Setting Up the Printer
Setting Up the Printer
Reference
Setting Up the Printer
Setting Up the Printer
Setting Up the Printer
Setting Up the Printer
67