Usb Device Setting; Usb Operation Mode; Usb Storage Function - Foxconn BLACKOPS User Manual

USB Device Setting

USB 1.1 Controller
USB 2.0 Controller

USB Operation Mode

USB Storage Function

*** USB Mass Storage Device Boot Setting ***
↑↓��������:Move Enter:Select ��������:Move Enter:Select
F5:Previous Values
► USB 1.1 Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
► USB Operation Mode
This item is used to set the USB operation mode. If you select the �High Speed��, then the USB
operation mode is determined by the USB device; select �Full/Low Speed��, the USB device
operates on full/low speed.
► USB Storage Function
This option is used to set whether the USB Mass Storage controller is enabled in a legacy
operating system (such as DOS).
► ***USB Mass Storage Device Boot Setting***
BIOS auto detects the presence of USB Mass Storage Devices, you can configure the Boot
setting mode for the detected USB MSD.
Phoenix - AwardBIOS CMOS Setup Utility
USB Device Setting
:Move Enter:Select +/-/PU/PD:Value F10:Save +/-/PU/PD:Value F10:Save +/-/PU/PD:Value F10:Save
F6:Fail-Safe Defaults
Enabled Enabled
Enabled
High Speed Menu Level ►
Enabled
�Enable�� or �Disable��
Universal Host
Controller
Interface for Universal
Serial Bus
ESC:Exit F1:General Help ESC:Exit F1:General Help ESC:Exit F1:General Help
F7:Optimized Defaults
37
Item Help