Table of Contents
Advertisement
E-IDE (ATAPI) Connection Set Up
Installing the CRW2200E
6 6 6 6 As an supplemental drive:
Remove the front cover of a vacant 5.25-inch drive bay slot of the computer in
case of using the CRW2200E. ( P. 25 step 10)
As a replacement drive:
Remove the device such as CD-ROM from the computer for CRW2200E.
( P. 25 step 10)
7 7 7 7 Slide the drive backwards into the slot, then tighten the four fastening
screws on the sides of the unit to hold the drive in place.
( P. 26 step 11 11 11 11)
8 8 8 8 Connect the IDE cable.
Connect the 40-pin IDE cable to the IDE connector on the motherboard and to the
IDE interface connector on the rear panel of the CRW2200E. Be sure to plug in
the cable so that the colored line on the cable corresponds to pin 1 on the right end
of the connector. The pin 1 of the IDE connector is labeled on the motherboard,
or refer to the documentation that came with your computer.
Motherboard
Notes
• The included IDE cable supports the UltraDMA/33 mode, and does not support the
UltraDMA/66 mode and the UltraDMA/100 mode. Please note that the IDE devices
connected to the included IDE cable cannot be operated with the UltraDMA/66 mode and
the UltraDMA/100 mode.
• Using with a UltraDMA/66 mode compatible IDE cable, the CRW2200E is supported.
• When connecting by a commercial IDE cable or a IDE cable included with your computer,
use the length of cable 18 in. (45.7 cm) or less.
• When you connect two IDE devices to one IDE cable, be sure to assign each as MASTER
or SLAVE respectively.
43
IDE connector
40-pin IDE cable
Colored line
IDE interface
connector
Colored line
Advertisement
Table of Contents
