Table of Contents
Advertisement
Parity Check
The parity check is used for error correction during data transmissions. If parity-
checking has to be disabled, the shunt on the Parity jumper switch should be
removed.
Parity ON (Default)
Normally leave this
setting alone.
1
2
4
The setting allows for the parity
checking. Normally, set PARITY
to ON to enable error correction.
Note
By factory default, the Parity switch is set to "ON" and should normally be left in this state.
Termination
Terminators prevent SCSI signals from being reflected off the last device in the
chain. The SCSI terminator switch should be set to "ON" if the CRW2200S is
the last device on the internal SCSI chain. If the CRW2200S is not the last device
on the internal SCSI chain, the shunt on the Terminator jumper switch should be
removed.
Hard disk drive
(unterminated)
MO drive
(terminated)
Terminator
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SCSI Connection Set Up
Parity OFF
ID SELECT
TERMINATOR
BLOCK SIZE
1
2
4
The setting does not
allow for parity
checking.
Computer
CRW2200S
(terminated)
SCSI card
PARITY
22
Advertisement
Table of Contents
