Yamaha CRW2200S Series Owner's Manual page 30

Cd-r/rw drive

Hide thumbs Also See for CRW2200S Series:

Table of Contents

SCSI Connection Set Up

Installing the CRW2200S

10 10 10 10 As a supplemental drive

Remove the front cover of a vacant 5.25-inch drive bay slot.

Note

To remove the front cover, refer to the documentation that came with your computer.

As a replacement drive

Disconnect all the cables connected to the rear of the existing CD-ROM drive,

and also disconnect the audio cable from the sound card or motherboard's audio

connector. Remove the CD-ROM of your computer.

(In the illustration below, the devices show, are all IDE type. The procedure for

SCSI type installation is the same.)

Audio cable

Notes

• Care should be taken not to damage cables connected to the rear of the CD-ROM drive.

• The Audio connecting cable is equipped with a locking mechanism to secure it in place. To

release the lock, lift up the connector and gently pull it out.

• Do not apply excessive force to the CD-ROM drive.

• If the removed device is an IDE type and set to MASTER, the other device that is on the

same cable should be changed from SLAVE to MASTER. ( P. 39 – 41)

40-pin IDE cable

5.25-inch drive bay slot

Front cover

4-pin power cable

Table of Contents