Table of Contents
Advertisement
The following explains how to add the drive to the computer as illustrated.
If you are replacing the existing CD-ROM drive, the procedure is basically the same.
Note
The way of installing built-in devices may differ, depending on the computer.
Refer also to the documentation that came with your computer.
11 Slide the drive backwards into the slot, then tighten the four fastening
screws on the sides of the unit to hold the drive in place.
Notes
• Do not apply excessive force when sliding the drive backwards into the drive bay slot.
• Leave enough room behind the drive to connect the power, SCSI, and audio cables.
12 12 12 12 Connect one end of the 50-pin SCSI flat cable to the computer's SCSI
card. Align the colored line of the cable with Pin 1 of the card's SCSI
connector. Next, connect a free 50-pin connector on the SCSI flat cable
to the back of the CRW2200S such that the colored line on the cable is
aligned with pin 1, marked "SCSI INTERFACE CONNECTOR 1."
Motherboard
SCSI connector
Colored line
Colored line
50-pin SCSI flat cable
SCSI Connection Set Up
SCSI INTERFACE
CONNECTOR
26
Advertisement
Table of Contents
