Table of Contents
Advertisement
Setting the Jumper Switches
8 8 8 8 Before fitting the CRW2200S into the computer, you need to set up the
drive using the jumper switches located at the rear of the unit. You'll
need to set the following:
SCSI ID number
Parity check
Termination
Block size
To set each jumper switch, you have to bridge the two pins in the respective
column of the grid with a plastic shunt. Shunts are already attached to the jumper
switches in their default configurations.
Jumper switches
1 2 4
Note
The plastic shunts actually contain metal for bridging the two pins of a jumper switch,
creating an electrical connection between them when attached. When removed, the jumper
switch is set to "OFF." Store unused shunts in a safe place where they will not be lost.
Use a pair of long-nosed pliers to attach or detach the plastic shunts
accordingly. Make sure that the computer is turned off beforehand.
ID SELECT
PARITY.
TERMINATOR
BLOCK SIZE
SCSI Connection Set Up
Rear Panel
20
Advertisement
Table of Contents
