Entering Program Mode; Program Menus - Ultra Start 35 Series Install Manual

REMOTE VEHICLE STARTER

Entering Program Mode

1) With the ignition in the OFF position, turn the ignition key from "Off" to "On" 3 times,
ON-OFF-ON-OFF-ON within three seconds. (Leave the key in the ON position)
2) Press and release the Program Button located on the antenna. The park lights will
flash and the horn (optional) will honk to confirm entering program mode.
3) Select desired Program Menu (See below). The park lights will flash and horn
(optional) will honk to confirm the selected menu.
4) Select Programmable Setting:
a) Press and release the Program Button the correct number of times to select the
desired Program Setting. The park lights and LEDs will flash and the horn (optional)
will honk to indicate the Program Setting that has been selected. For example:
1 flash/honk= Program Setting 1; 2 flashes/honks= Program Setting 2; etc...
b) Press and Hold the Program Button until the park lights flash and the horn(optional)
honks to confirm the desired setting. For example: 1 flash/honk= Setting 1;
2 flashes/honks= Setting 2; 3 flashes/honks= Setting 3.
c) Turning the ignition key to the "Off" position or 30 seconds of no activity will exit
Program Mode. This will be confirmed with a light flash and a long horn (optional)
honk. The Program Menu may be changed at any time by pressing the transmitter
button (below), this will allow the installer to jump from one menu, then quickly jump
to another menu and change another setting without re-entering Program Mode.
Note: If unit does not enter Program mode, turn ignition off for 5 seconds and repeat
steps 1-4.
Ignition 3x
Press and
On/Off
Release
On/Off On

Program Menus

Menu 1: User Settings (Lock Button)
This program menu is for the adjustments for the user and door lock options.
Menu 2: Additional Settings (Unlock Button)
This program menu is for additional settings.
Menu 3: Starter Settings (Start Button)
This program menu is for various remote car starter applications.
Menu 4: Tach Settings (# Button)
This program menu is for tach signal adjustments.
1 2 3
4
Press button Press button
1 for Menu 1 2 for Menu 2
INSTALLATION MANUAL
1 2 3
4
Press button
3 for Menu 3
Page 13
1 2 3
1 2 3
4
Press button
4 for Menu 4
Page 16
Page 17
Page 18-19
Page 20
4