Sanyo VCC-XZ400P Instruction Manual page 42

OPTION SETTING
ALARM setting
3
Use the CURSOR button (jldc) to
make the settings given below.
1
POLARITY
NO: Normal open (Normally open, and
mode switches between color and
black & white when closed.)
NC: Normal closed (Normally closed, and
mode switches between color and black
& white when opened.)
POLARITY Between
ALARM IN
and GND
NO Normal open Color
Closed
NC Normal
closed
Open
2
MOTION
OFF: Does not output a motion sensor
alarm.
OR: Outputs an alarm if a motion sensor
alarm is detected.
Note:
If DAY/NIGHT has not been set to COLOR,
the Color or Black/White selection will not be
possible.
If COLOR for ALARM IN is selected, settings
relating to external alarm input will not be
displayed, and it will not be possible to
receive the external alarm inputs.
The Color or Black/White selection settings
is applied from the point after the menu is
exited.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
B
Connect the ALARM OUT cord to buzzer or
lamp, etc.
1
Use the CURSOR button (j or l) to
move the cursor to ALARM OUT, then use
the CURSOR button (d or c) to select
ON or OFF.
ON: Output an alarm (for activation of
OFF: Does not output an alarm
Mode after
selection
B/W
B/W
Color
2
Use the CURSOR button (jldc) to
make the settings given below.
1
NO: Normal open (Normally open so closed
NC: Normal closed (Normally closed so
2
Select the amount time for external alarm
output.
Available settings: 5S (Seconds), 10S,
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
41
ALARM OUT (Alarm output setting)
buzzer or lamp)
ALARM SETTING
ALARM IN ZOOM
POLARITY NO
MOTION x1.4
DURATION 5S
ALARM OUT OFF
POLARITY NO
ALARM TIME 5S
LINE OUT OFF
PRESET OFF
MENU BACK
POLARITY
condition is detected as input.)
open condition is detected as input.)
ALARM TIME
15S, 20S, 30S, 1M
(Minute), 2M, 3M, 4M,
5M