View Angle Setting; Mirror Setting - Sanyo VCC-XZ400P Instruction Manual

LENS SETTING

VIEW ANGLE setting

The VIEW ANGLE setting should normally be
left at "OFF".
1
In the MAIN MANU, use the CURSOR
button (j or l) to select SET for LENS,
then press the SET button.
The LENS screen will appear.
2
Use the CURSOR button (j or l) to
move the cursor to VIEW ANGLE, and
then use the CURSOR button (d or c) to
select the setting.
Available settings:
OVER: The image angle for images being
monitored is set to 1.05.
OFF: This should normally be set to "OFF".
Note: This should normally be set to "OFF".
However, vignetting may occur in the
corners of the images because of the
zoom position. This is not normally a
problem, but if you are concerned about
it, change the setting to "OVER". The
vignetting will then be less apparent.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.

MIRROR SETTING

In the MAIN MENU, use the CURSOR button
(j or l) to move the cursor to MIRROR,
then use the CURSOR button (d or c) to
select the mirror image effect.
Available settings:
OFF: Normal image
H: Inverted horizontally
V: Inverted vertically
HV: Inverted horizontally and vertically
OFF H
To return to the normal screen, use the
CURSOR button (l) to select END at the
bottom of the screen, then press the SET
button.
25
V HV