Camera Id Setting; Sync Setting - Sanyo VCC-XZ400P Instruction Manual

3
Use the CURSOR button (j or l) to
move the cursor to SET for POSITION,
and then press the SET button.
The camera ID will be displayed on one line.
Camera ID
4
Use the CURSOR button (j l d c) to
move the title display to the preferred
position on the screen, then press the
SET button.
The CAMERA ID SETTING screen will
reappear.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.

SYNC SETTING

Default setting is internal synchronization (INT),
so it does not need to be set again. Follow the
steps below to change the setting to power
source synchronization (L-L).
However, vertical sync disturbance may occur
when a selector is used to switch between
multiple cameras connected to one monitor. To
prevent vertical sync disturbance, set to L-L
(Line-Lock).
1
In the MAIN MENU, use the CURSOR
button (j or l) to move the cursor to
SYNC, and then use the CURSOR button
(d or c) to change the setting to L-L.
Then press the SET button.
The L-L SETTING screen will appear.
2
Use the CURSOR button (j or l) to
adjust the position of the vertical
synchronization indicator shown on the
screen.
The numerical value will change, allowing
adjustment of vertical synchronization.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
14