Sanyo VCC-XZ400P Instruction Manual page 37

5 DEMO: Detected motion confirmation
mode (ON/OFF)
When a motion is detected, patterns are
shown in that location. While the detected
motion is being confirmed, the SENSITIVITY
settings are optimized. This mode can only
be activated in the SENSITIVITY setting
screen.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen , select BACK or END for
MENU and press the SET button.
ZOOM setting
D
Use the CURSOR button (j or l) to move
the cursor to ZOOM, then use the CURSOR
button (d or c) to select the zoom
magnification power.
Available settings: OFF, x1.4, x2, x2.8, x4, x6
Note:
When a suspicious motion is detected, the
camera zooms in according to the set
magnification power. The zoom takes effect
for 5 seconds and then returns to the
previous magnification level.
The zoom focuses on the center of the
screen. If the maximum optical performance
is exceeded, zooming will stop at maximum
magnification.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
INTERVAL setting
E
Use the CURSOR button (j or l) to move
the cursor to INTERVAL, then use the
CURSOR button (d or c) to select the time
interval.
Available settings: 5S (Seconds), 10S, 15S,
Note: When a motion is detected, no other
motions will be detected within the set
interval of time.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
ALARM SIGN setting
F
The camera ID display blinks when motion is
detected.
Use the CURSOR button (j or l) to move
the cursor to ALARM SIGN, and then use the
CURSOR button (d or c) to change the
setting to ON. Then press the SET button.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
36
20S, 30S, 1M (Minute),
2M, 3M, 4M, 5M