Sanyo VCC-XZ400P Instruction Manual page 33

AWC LOCK setting
With SET blinking for AWC LOCK, press the
SET button.
SET will light and adjustment of white balance
will begin. After about 3 seconds, SET will begin
blinking again, signaling that adjustment is
complete.
Note: Full adjustment may not be possible with
just one activation of SET for AWC
LOCK. In that case, press the SET button
again.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
GO TO MWB setting
For even finer adjustment of coloration, choose
SET for GO TO MWB. White balance mode will
become MWB for fine adjustment. After fine
adjustment with GO TO MWB, the white
balance mode will automatically switch to MWB.
Go to "_C_ MWB setting".
MWB setting
C
Fine adjustments for preferred colors can be
done manually. This method is preferable when
suitable colors cannot be obtained with the ATW
method.
1
In the VIEW SETTING screen, use the
CURSOR button (jldc) to select MWB
for WHITE BALANCE, then press the SET
button.
The MWB SETTING screen will appear.
2
Use the CURSOR button (jldc) to
make the settings given below.
1 R: red
Available settings: 0 – 255
The larger the number, the stronger red
becomes.
2 B: blue
Available settings: 0 – 255
The larger the number, the stronger blue
becomes.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
32