Sanyo VCC-XZ400P Instruction Manual page 36

VIEW SETTING
MOTION detector setting
MOTION MASKING setting
B
Masking target objects that are not desired for
detection (swaying trees, flickers of light, etc.)
will prevent unwanted alarms from being
generated. This is done in the MOTION
SETTING screen.
1
Use the CURSOR button (jldc) to
select ON for MASKING, then press the
SET button.
The MOTION MASKING screen will appear.
2
Use the CURSOR button (jldc) to
move the mask pattern to the target
object that is not to be detected, then
press the SET button.
Repeat these steps to set mask patterns
in other locations.
To clear a mask pattern, press the SET
button again on the pattern.
3
Use the CURSOR button (l) to move a
mask pattern to the bottom area of the
screen and continue holding it for 3
seconds.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
SENSITIVITY setting
C
Set the degree of sensitivity for motion detection
corresponding to MOTION SIZE. Sensitivity can
be set so that natural motions on the screen
such as wind and light changes will not be
detected. When this is necessary, activate the
following setting.
1
Use the CURSOR button (j or l) to
move the cursor to SET for SENSITIVITY,
then press the SET button.
The SENSITIVITY screen will appear.
When necessary, adjust the following
settings.
2
Use the CURSOR button (jldc) to
make the settings given below.
1 MOVE: Motion sensitivity setting
To avoid detection of small movements such
as wind, make the value larger.
Available settings: 1 – 10
2 Y-LEVEL: Brightness level
When noise from a dark screen is causing
erroneous detections, make the value larger.
Available settings: 1 – 10
3 Y-DIFFER: Brightness differences
Changes in brightness can sometimes be
mistakenly detected as motion. To avoid
detection of the turning on and off of lighting,
make the value larger.
Available settings: 1 – 10
4 DURATION:
To avoid detecting fast movements, make
the value larger.
Available settings: 1 – 60
35