Language Setting; Camera Id Setting - Sanyo VCC-XZ400P Instruction Manual

LANGUAGE SETTING

If you change the language shown on the menu
screen to the French or German, make the
settings given below.
1
In the MAIN MENU, use the CURSOR
button (j or l) to select SET for
LANGUAGE, then press the SET button.
The LANGUAGE screen will appear.
2
Use the CURSOR button (j or l) and
SET button to select the desired
languages.
The interface language becomes French or
German.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.

CAMERA ID SETTING

If using more than one camera, this lets you
assign different names (IDs) to each camera,
and the IDs can be made to appear on the
monitor.
1
In the MAIN MENU, use the CURSOR
button (j or l) to move the cursor to
CAMERA ID, and then use the CURSOR
button (d or c) to change the setting to
ON. Then press the SET button.
The CAMERA ID SETTING screen will appear.
1
2
3
1 Character selection palette:
By moving the cursor to letters or numbers in
this palette, you can select characters.
2 ID:
Selected characters will appear in the
corresponding field under ID.
3 POSITION:
Set the position where the camera ID is to
appear on the monitor.
2
Example:
Setting the Camera ID to "CAM 1"
Use the CURSOR button (j l d c) to
move the cursor to the letter "C" in the
character selection palette, then press
the SET button.
Use the same steps to select "A", "M"
and "1" from the palette, then press the
SET button.
After at least one character is displayed in
the ID field, the carriage return mark ( ) will
appear at the lower right corner of the
character selection palette. Selecting this
mark between the characters of the field will
create a new line at that place.
13