Ssh Client Source - HP 6125G Command Reference Manual

Description
Use ssh client ipv6 source to specify the source IPv6 address or source interface for the SSH client.
Use undo ssh client ipv6 source to remove the configuration.
By default, an SSH client uses the IPv6 address of the interface specified by the route of the device to
access the SSH server.
To make sure the SSH client and the SSH server can communicate with each other, and to improve the
manageability of SSH clients in the authentication service, HP recommends you specify a loopback
interface as the source interface.
Related commands: display ssh client source.
Examples
# Specify the source IPv6 address as 2:2::2:2 for the SSH client.
<Sysname> system-view
[Sysname] ssh client ipv6 source ipv6 2:2::2:2

ssh client source

Syntax
ssh client source { ip ip-address | interface interface-type interface-number }
undo ssh client source
View
System view
Default level
3: Manage level
Parameters
ip ip-address: Specifies a source IPv4 address.
interface interface-type interface-number: Specifies a source interface by its type and number.
Description
Use ssh client source to specify the source IPv4 address or source interface of the SSH client.
Use undo ssh client source to remove the configuration.
By default, an SSH client uses the IP address of the interface specified by the route of the device to access
the SSH server.
To make sure the SSH client and the SSH server can communicate with each other, and to improve the
manageability of SSH clients in the authentication service, HP recommends you specify a loopback
interface as the source interface.
Related commands: display ssh client source.
Examples
# Specify the source IPv4 address of the SSH client as 192.168.0.1.
<Sysname> system-view
[Sysname] ssh client source ip 192.168.0.1
211