Changing The Search Type; Changing The Search Band Memory - AOR AR-Mini Operating Manual

ADVANCED OPERATION

Changing the Search Type

The AR-mini has three searching
method types. These can be changed
when searching.
1
Start a search.
2
Press the SCAN key to change the
scan type.
• The scan type will be changed with
each press of the SCAN key, as
follows:
Busy Search ➝ Hold Search ➝
Time Search ➝ Busy Search ➝ ·····
• Busy Search: the "B" icon is lit.
The search will be paused while
receiving a signal. The search will
resume 2 seconds later when the
signal is gone.
• Hold Search: the "B" icon is
blinking.
The search will be stopped when
a signal is received.
• Time Search: No icon is
displayed.
The search will be paused
for 5 seconds when a signal
is received. The search will
resume 5 seconds later even if
a signal is received. If the signal
disappears during the 5 seconds
pause period, the search will be
resumed 2 seconds later. This
pause length can be changed by
setting number 07.
36
Changing the Search
Band Memory
The search band memory is preset
when the AR-mini is shipped. The
frequency of search band memory can
be changed.
1
Start a limit search.
2
Hold down the FUNC key and turn
the dial knob to select the memory
number to be memorised.
3
Hold down the FUNC key and
press the SCAN key for 2 seconds
or longer.
Tips:
The search band memories are
listed on page 74.