Searching Bug Frequencies; Using The Bug Detector Function - AOR AR-Mini Operating Manual

ADVANCED OPERATION
Searching Bug
Frequencies
How to scan the 119 pre-installed
(unmodifiable) bug frequencies.
1
Confirm that VFO is set.
2
Hold down the SCAN key for 2
seconds or longer.
• "t" icon will displayed.
• When a strong signal is found, it will
be displayed.
• Up to 20 received frequency signals
can be memorised. These can be
confirmed by turning the dial knob.
• When no signal is found, "NON" will
be displayed.
3
To cancel, press the V/M key or
dial knob.
4
To return to VFO, press the dial
knob or V/M key.
Tips:
• For ease of use, select setting
numbers 04 (S-meter Sensitivity)
and 05 (S-meter Buzzer).
• The searching bug frequencies are
listed on page 70.
Using the Bug Detector
Function
This function indicates signal strength
via a beep tone.
1
Search the bug frequency as described
in "Searching Bug Frequencies".
2
Recall the memorised bug
frequency by turning the dial knob.
3
Hold down the FUNC key and
press the SCAN key for 2 seconds
or longer.
• S-meter sensitivity is set to low and
the attenuator function is set.
4
Press the V/M key to return to
displaying the bug frequency.
5
To return to VFO, press the dial
knob or V/M key.
Tips:
In step 3 the beep tone is changed
as follows:
Slow pitch beep: Weak signal
Middle pitch beep: Medium strength signal
Fast pitch beep: Strong signal
49